Lithium polymer battery use and Assembly considerations
Lithium polymer battery is a electrolytic quality for gel
rubber-like, and packaging soft of lithium battery, in civilian market often
was called soft package lithium battery, this makes lithium battery electric
core has and General liquid lithium ion battery not as of place, thus some
special of note matters, following on electric core in using and assembled
process in the may appeared of not right practices proposed following note
matters.
First, in the use of batteries, including on
aluminum-plastic composite films, top edge (end edge), lateral edge, its
protection and measures to avoid mechanical impact, short circuit.
1 Aluminum-plastic laminated film packaging protection:
mainly to avoid being stabbed sharp parts are damaged. To this end, should
often clean batteries around the environment, contact against sharp parts or
bump the batteries, take time to wear gloves, avoid fingernails scratching the
surface.
2 The top edge and side edge protection: to avoid damage
to edges and side edges, damage the sealing effect, bending the top edge should
be forbidden and side edge and core design reliable insulation isolation
measures must be taken to avoid negative and the butt welding of
aluminum-plastic composite film short circuit.
3 Handles protection: lithium polymer battery positive
terminal aluminum handle, cathode Terminal nickel handles. Due to the very thin
handle, bent should be prohibited and should be avoided during the production
process handles contact with the aluminum-plastic composite film, with strict
isolation rings film.
4 Avoid mechanical impact, such as falls, curb and
bending batteries and accidentally trample on batteries.
5 Or the use of metal, wires and short circuits the
connection polarity.
One battery ready, the next step is combined with the
shell and battery protection circuit module correctly, making it a polymer
battery, considerations for this process are:
1 Shell design: a. with sufficient mechanical strength to
prevent the batteries from external mechanical damage b. When installing the
enclosures, batteries, avoid the sharp edges of the shell scratch batteries and
c. Prevention of aluminum-plastic composite membrane laminated aluminum in
contact with external short circuit.
2 Batteries must be designed to protect circuits:
including scientific set of minimum voltage, over current protection, turbine
core using a combination of battery unit (single core) to overcharge
protection.
3 Aluminum handle, positive transfer through nickel, as
well as batteries and circuit board connections should use ultrasonic welding
or spot welding technology.
4 Positioning, reliable batteries, batteries assembled
fastened within the shell, and not activities, so that the whole structure of
lithium ion battery in a State of consolidation.
Comments
Post a Comment